Pleasant View Electronics

Electronic Prototyping & Supplies - Arduino - Sensors - Raspberry PI - Resistors - Diodes - Etc...

Arduino BlueBoard Kit

$15.95

13 in stock (can be backordered)

SKU: PVT-0030108 Category: Tags: , , ,

Description

This Solder Kit has everything included to build an Arduino development board.

After some basic soldering, you’ll have made a fully-functional Arduino-compatible development board.
The included ATmega328 comes pre-loaded with the Arduino bootloader so you don’t have to load the bootloader firmware, connect an FTDI USB-Uart Bridge and upload your sketch using the Arduino IDE.

After the board is assembled, it can be powered by an FTDI Adapter or a regulated 7.5-15VDC power supply connected to either the DC Barrel jack the 2 pin headers.We recommend using 9v Wall adapter if using the DC Barrel jack.

In order to program with the Arduino IDE, You will need a USB-Uart Adapter or FTDI cable to upload code using the Arduino IDE.

Kit Includes:

1 x Arduino-Form Factor PTH PCB
1 x ATMega328 with bootloader
1 x L78L33ACZ 3.3V 0.1A Voltage Regulator
1 x 5mm Blue LED
1 x 5mm Red LED
2 x 330Ohm Resistor
2 x 10kOhm Resistor
1 x 16MHz Crystal
2 x 22pF Ceramic Capacitors
5 x 0.1uF Ceramic Capacitors
2 x 10uF Electrolytic Capacitors
1 x LM7805T 5V Regulator
1 x Diode 1N4001
1 x Resettable 1Amp PTC Fuse
1 x 28-Pin DIP Socket (so that you can replace the chip)
1 x Tactile Reset Switch
2 x 6-Pin Female Headers
2 x 8-Pin Female Headers
1 x 6-Pin Right Angle Header (To connect your FTDI Basic)
1 x DC Barrel Jack

Pleasant View Electronics, Golden, Colorado © 2017 Frontier Theme